70-660, MicroSoft 70-660 試驗
定試験の詳細
試験番号: 70-660
試験名: TS:Windows@ Internals
あなたの職業ライフとCisco認定の道で認定 「専門家の解説した Q & As」認定試験は核心とされています。本当の答案をまだ捜しますか。CramBibleはあなたの絶好の選択です。CramBibleのテストエンジンを使用なら、のブレインダンプのサイト内容を期待あなたにとっては、問題と答案だけでなく、合格と精確の説明も手に入ります。そのため、あなたは試験情報をしっかりと把握できます。練習資料を使用して、初めてのチャレンジでを通過できるとCramBibleが保証します。
試験:
1) 基本的に6つのステップでは、証明書、つまり、あなたの道を得るために従ってくださいです:
2) どの証明書が正しい場合は - 認証の概要を取得するためには決定
3) ゲインハンズフリー製品 - プロフィールの要件の特定の認証のための経験に
4) 展開訓練は、トレーニング教材を使用してくださいとあなたの経験。ある優秀なPDF形式の資料は3cb.comから入手、そのスタッフの専門家によって準備される.
5) 知っているか試験に期待する - レビュー良い学習ガイド.
6) あなたに必要な試験を取る - のいずれかプロメトリックまたはピアソンVUEテストセンターで登録できます.
7) 無料アップデート90日.
70-660 に関する試験
認定試験
- 70-540(CSharp) Microsoft Windows Mobile Application Development
- 70-540(VB) Microsoft Windows Mobile Application Development
- 70-400 70-400 : TS:MS System Center Operations Manager, Configuring
- 70-541(CSharp) MS Windows SharePoint Srvcs 3.0 Application Development
- 70-541(VB) MS Windows SharePoint Srvcs 3.0 Application Development
- 70-544(CSharp) Ms Virtual Earth 6.0, Application Development
- 70-544(VB) Ms Virtual Earth 6.0, Application Development
- 70-556 Ms Office PerformancePoint Server 2007, Applications
- 70-656 Microsoft Desktop Optimization Pack, Configuring
- 70-639 MSOffice Proj Serv 2007, Config, For MS Cert Parthers
- 70-680 TS:Windows 7,Configuring
- 70-582 Windows Embedded Standard 7 for Developers
-
Microsoft TS 70-660 Web Demo
This webdemo is just a demo data, only for reference and learning, there is no other purposes.
1.You are developing a user mode application that contains two processes.
You need to allow the two processes to synchronize access to a shared data area.
Which synchronization primitive should you use?
A. Critical Section
B. ERESOURCE
C. Mutex
D. Spinlock
Answer: C
3. You have a device driver that has one monitoring thread named
Thread1. The device driver has three worker threads named Thread2,
Thread3, and Thread4. The worker threads run every 10 seconds and
complete within 1 second. If any worker thread does not run at least
once every 30 seconds, Thread1 calls KeBugCheckEx, and then a complete
kernel crash dump is generated.
The computer generates a bug check and a complete kernel dump is generated.
You review the complete kernel dump and notice the following:
You need to identify the root cause of the bug check.
What caused the bug check to occur?
A. the priority of Thread1
B. the priority of Thread4
C. the state of Thread1
D. the state of Thread2 and Thread3
Answer: B
4. You develop a device driver for a PCI device. The PCI device runs on Windows Server 2003 computers.
You test the device driver's interrupt processing. The computer stops responding.
You need to locate the list of interrupt handling routines in the crash dump by using WinDbg.
Which command should you use?
A. !idt
B. !ipi
C. !irql
D. !isr
Answer: A
5. You develop a device driver for Windows XP that runs on uniprocessor
systems only. The driver creates a system thread and a deferred
procedure call (DPC). The DPC is invoked by a repeating timer.
The thread and the DPC must process entries from the same work queue.
You need to ensure that the system thread and the DPC are synchronized.
Which IRQ Level (IRQL) should you use?
A. APC_LEVEL
B. DISPATCH_LEVEL
C. LOW_LEVEL
D. PASSIVE_LEVEL
Answer: B
6. You develop a Windows device driver for a hardware device. The
hardware device uses a simple direct memory access (DMA) controller.
The hardware device does not perform virtual address translation.
You need to allocate a 64-KB buffer in Windows that accepts a DMA transfer of 64 KB from the hardware device.
Which routine should you use?
A. AllocateHeap(655536)
B. ExAllocatePoolWithTag(PagePool, 65536, 'abcd')
C. ExAllocatePoolWithTag(NonPagePool, 65536, 'abcd')
D. MmAllocateContiguousMemory(65536, 0xFFFFFFFF)
Answer: D
7. You are writing an I/O dispatch routine for a Windows device driver.
The device driver supports buffered I/O. The dispatch routine transfers
1 KB of data to the user process.
You need to retrieve the kernel address of the 1-KB buffer from the I/O request packet (IRP).
Which field of the IRP contains the kernel address?
A. Irp->AssociatedIrp.SystemBuffer
B. Irp->Overlay.UserApcContext
C. Irp->Tail.Overlay.DriverContext[0]
D. Irp->UserBuffer
Answer: A
8. You plan to update a device driver on a Windows system. You download
a copy of the device driver file from the Internet, but you are
uncertain that the device driver is legitimate.
You need to verify the device driver's digital signature.
Which tool should you use?
A. Certmgr.exe
B. Certmgr.msc
C. Makecert.exe
D. Signtool.exe
Answer: D
2. You are developing an application.
You need to ensure that the application can read from COM port 10 by using the CreateFile function.
Which device name should you open?
A. "COM10"
B. "%COM10%"
C. "\COM10"
D. "\\.\COM10"
Answer: D
?>